Semi automatic coating filling machine

ystem introduction
Dcs-50-ctzs coating filling machine is widely used in the filling of coating, ink, glue and other liquid materials. According to years of rich experience, the unique filling valve design is easy to disassemble, change size and clean. The filling head is made of 304 stainless steel + Teflon material, which makes the filling head resistant to high temperature, corrosion and drip. The operator simply needs to place the bucket mouth on the weighing platform and align it directly below the outlet of the filling head, pull the [operation switch] on the control box to [automatic], and the system will automatically start filling. First, fast filling is adopted, and at the end stage, slow filling is adopted to fill the materials into the bucket quickly and accurately. After filling, the filling head will automatically close the valve, and the operator will gently push the heavy bucket to the intermediate conveying line, The machine automatically transports the packaged products to the next station. It can be configured with automatic capping, automatic capping and automatic capping on-line to complete the filling. When the second barrel is filled, the operator places the empty barrel directly under the filling head without touching the switch again. When the hand leaves the barrel, the system will automatically start the filling.
Parameters：
■ maximum weighing capacity: 30kg ■ minimum sensing capacity: 0.001kg
■ filling error: ± 5g ■ filling speed: 10 barrels / minute (depending on the feed flow rate)
■ control mode: two gear control ■ material interface: Dn40 clamp type quick release interface
■ air source interface: 10mm air pipe interface ■ power supply: 220V / 50Hz wire provided by the user to the machine side
■ air source: 04mpa-0.8mpa 10mm air pipe (provided by the user to the machine side)
■ service temperature: - 10 ℃ - 50 ℃   ■ foundation condition: horizontal solid concrete ground, concrete thickness shall not be less than 10cm